Configure NAS devices to access the TACACS+ server
In this topic, you will find tips on how to configure your NAS devices to access the Portnox™ Cloud local TACACS+ server.
Note:
This topic only contains examples to guide you. Consult your NAS device documentation for specific instructions on how to set
up TACACS+ on your NAS devices.
To configure your NAS device to use the local TACACS+ server, you will need the following information:
The IP address of the local TACACS+ server, in our examples: 10.0.0.124
()
The shared secret to access the local TACACS+ server, in our examples: 7cH3vCaXaB67WhfSEqUtGNa5
()
Important:
If you use TACACS+ MFA, set the TACACS+ timeout on the NAS device to the same value as the
Push-to-access notification timeout in the group settings (see the following topic: Set up multi-factor authentication for TACACS+). Some NAS devices don’t support the longest group timeout values. For example, Aruba AOS-CX
switches allow a maximum of 60 seconds. Select a group timeout that all your NAS devices support.
The following are examples of configuration for common NAS devices. The examples set the TACACS+ timeout to 45 seconds.
Cisco
aaa authentication login default group tacacs+ local
aaa authorization exec default group tacacs+ if-authenticated
aaa authorization network default group tacacs+ if-authenticated
aaa accounting exec default start-stop group tacacs+
aaa accounting network default start-stop group tacacs+
tacacs server PORTNOX
address ipv4 10.0.0.124
key 7cH3vCaXaB67WhfSEqUtGNa5
timeout 45
Aruba
tacacs-server host 10.0.0.124 key 7cH3vCaXaB67WhfSEqUtGNa5
tacacs-server timeout 45
(config)#aaa authorization commands tacacs
Juniper
set system tacplus-server 10.0.0.124
set system tacplus-server 10.0.0.124 secret 7cH3vCaXaB67WhfSEqUtGNa5
set system tacplus-server 10.0.0.124 source-address 10.0.0.1
set system tacplus-server 10.0.0.124 timeout 45
set system authentication-order [tacplus password]
set system login user remote class operator